Touch-up Paint Tips for Metal Roofs
There are many touch-up paint tips for metal roofs available, but the best advice we can offer is to carefully consider your options and the finished appearance you’re looking for.
Scratches and very minor damage may occur during the handling and installation of painted roofing and wall panels. In these instances, it may be desirable to use touch-up paint to repair the blemishes. Keep in mind, touch-up paints are quick fixes and when used properly, will result in a satisfactory appearance. Misuse or over-use can result in spoiling the overall appearance.
The paint systems used on factory painted steel have a built-in color and gloss retention that is only achieved through the oven-baked process. Air-dried paints will fade and chalk much faster than oven-baked. These different weathering characteristics must be taken into consideration when touch-up work is contemplated.
Nothing looks worse than the blotchy appearance of an excessive touch-up painting. Superficial scratches that are not too obvious from 6-9 feet will likely be obscured by normal soiling and weathering.
If you decide to use touch-up paint, use it sparingly and only to cover up those areas where paint has been removed. Below are steps to prepare the metal before using touch-up paint.
- Use a paint pen or 1/4″ artist brush – Only the narrow edge of the paintbrush should contact the scratch or blemish
- Lightly sand or “feather” with #400 grit sandpaper for edges of deep scratches
- Treat scratches that expose raw steel (scratches through the paint and protective metal layer) should be treated with a zinc-rich (or similar primer) before colored touch-up application
- If feathering and/or priming are not necessary, areas to be touched-up should at least be wiped with mineral spirits to remove dirt, wax, or other contaminants before colored touch-up application
The recommended paint type for touch-ups is an acrylic silicone paint. There are two paint types that can be used in conjunction with our products. Be sure to have the ASC Building Products metal roof or metal wall profile information available when inquiring about paint types. Paint can also be sourced through PPG Industries.
Special attention should be given to the manufacturer’s instructions including direct skin or eye contact, ventilation, and potential flammability. Aerosol or spray applications are not recommended for blemish or scratch repairs.
For more information about Touch-up Paint Tips for Metal, please visit our Ask ASC Building Products and send us your questions.
Did you find this article helpful?